Water Worker G12L Guía de instalación descargar pdf (Pagina 5)

INSTALLATION INSTRUCTIONS

Read completely before proceeding and

refer to typical installation diagram and photos.

1. Measure pre-charge pressure with a

tire gauge to ensure pressure is the

same as water pressure. Tank comes

charged to 40 psi. Increase pressure

as needed.

4. Open hot waer faucet to relieve

pressure. Close faucet when pressure

subsides (ﬂow stops).

Typical “Completed” Installation

2. Turn water heater to the lowest

temperature setting.

5. Apply Teﬂon

®

tape to tank threads.

3. Shut off water supply main valve.

6. Screw tank into saddle valve.

IMPORTANT, use wrench ﬂats to

tighten tank into position.

1 2 3 4 5 6 7 8 9 10 ... 23 24

Comentarios a estos manuales

Sin comentarios